opensc-tool 1 OpenSC OpenSC Tools opensc opensc-tool generic smart card utility opensc-tool OPTIONS The opensc-tool utility can be used from the command line to perform miscellaneous smart card operations such as getting the card ATR or sending arbitrary APDU commands to a card. --version, Print the OpenSC package release version. --atr, -a Print the Answer To Reset (ATR) of the card. Output is in hex byte format --card-driver driver, -c driver Use the given card driver. The default is auto-detected. --list-algorithms, Lists algorithms supported by card --info, -i Print information about OpenSC, such as version and enabled components. --list-drivers, -D List all installed card drivers. --list-files, -f Recursively list all files stored on card. --list-readers, -l List all configured readers. --name, -n Print the name of the inserted card (driver). --get-conf-entry conf, -G conf Get configuration key, format: section:name:key --set-conf-entry conf, -S conf Get configuration key, format: section:name:key:value --reader arg, -r arg Number of the reader to use. By default, the first reader with a present card is used. If arg is an ATR, the reader with a matching card will be chosen. --reset type, Resets the card in reader. The default reset type is cold, but warm reset is also possible. --send-apdu apdu, -s apdu Sends an arbitrary APDU to the card in the format AA:BB:CC:DD:EE:FF.... --serial Print the card serial number (normally the ICCSN). Output is in hex byte format --verbose, -v Causes opensc-tool to be more verbose. Specify this flag several times to enable debug output in the opensc library. --wait, -w Wait for a card to be inserted. opensc-explorer 1 opensc-tool was written by Juha Yrjölä juha.yrjola@iki.fi.